Error 17 Washer Bosch

What is the fault of Bosch Error 17 affecting your washing machine?

We're here to help! Has the error code 17 appeared on your Bosch washing machine, and you're unsure of what it means or how to resolve it? You have nothing to worry about; we will explain everything you need to know right here about this annoying issue that can affect the operation of your appliance.

Error code 17 indicates that there is a problem with the water supply to the washing machine. It goes without saying that this essential fluid is crucial for the proper functioning of your appliance.

This error code 17 that affects Bosch washing machines can be due to various causes, such as:

• The tap or main water valve being closed or having low pressure
• A leak in the water supply, hoses, seals, or filters
• The inlet water filter being dirty or clogged
• A bent, broken, or blocked water inlet hose
• The water level sensor being faulty or dirty

Any of these causes can prevent the washing machine from properly filling the drum with water and, consequently, performing the washing cycle normally. That's why it's important to check each of these possible causes and the solutions we propose below.

How to fix Bosch washing machine Error 17?

To resolve error code 17 on Bosch brand washing machines, you can follow the steps we provide below. Most of them can be done by yourself without the need for a technical service:

1. Reset the washing machine to reset the sensors: If you suspect that you have this error as a false positive on your washing machine, let's first try to reset it to restart the sensors. Sometimes, excessive foam can cause the sensors to go haywire, so let's give it a shot! To do this, you'll need to completely turn off your washing machine and unplug it from the electrical outlet for a few minutes. Then, plug it back in, turn it on, and check if error code 17 has disappeared.
2. Turn on the faucet and check for sufficient water pressure: It may seem obvious, but remember that this error code is related to a water supply failure. So, you'll need to check if your washing machine is indeed receiving the necessary liquid for its operation. Open the water faucet fully and make sure the water flow is smooth and steady.
3. Inspect and repair potential water leaks in your washing machine's circuit: Conduct a thorough inspection of the entire water circuit in your washing machine. Look for possible leaks in the hoses, at the water inlet, the filter, and the valves. If you find a leak, you'll need to repair it as soon as possible to ensure your washing machine receives the water it needs to function correctly.
4. Clean the inlet water filter: The filter is located at the back of the washing machine, where the water inlet hose is connected. Disconnect the hose and carefully remove the filter. Now, clean it with a soft-bristle brush, warm water, and a bit of vinegar. Then, reattach the filter and connect the hose. If you notice that the filter is damaged or in very poor condition, you'll need to replace it with a new one.
5. Check the water inlet hose: Ensure that this hose is not bent, broken, or obstructed in any way. If it is, try to repair it, although we recommend replacing it with a new one. You can also try repositioning it to prevent it from bending or getting stuck against the wall or the washing machine itself.
6. Clean or replace the water level sensor: The sensor is located at the bottom of the drum, near the drain pump. To access it, you'll need to remove the lower front panel of the washing machine. Disconnect the sensor's cable and carefully remove it, then clean it with electronic cleaner and reinstall it. If it's faulty, you'll need to replace it with a new one.
7. Repeat all the previous steps if the problem persists: Make sure to follow everything we've instructed to the letter. This issue has an easy and quick solution! However, if you've tried everything for the second time and error code 17 continues to appear, it might be time to leave it in the hands of an expert.
8. Contact Bosch technical support to resolve the issue: If none of the above works, it's best to contact Bosch's official technical support for a professional to inspect your washing machine and provide a definitive solution. We're confident that you'll be in good hands, as Bosch's qualified technicians will offer you a prompt, efficient, and effective solution.

In summary, and to conclude this article: Resolving error code 17 on your Bosch washing machine can be done easily and quickly. This error is completely fixable, and you don't have much to worry about, as it doesn't mean you have to throw your washing machine away or buy a new one. This error code 17 on Bosch washing machines indicates a problem with the water it receives. To resolve this issue, you can do the following:

• Reset the washing machine to reset the sensors
• Turn on the faucet and check for sufficient water pressure
• Inspect and repair potential water leaks in your washing machine's circuit
• Clean the inlet water filter
• Check the water inlet hose
• Clean or replace the water level sensor
• Repeat all the previous steps if the problem persists
• Contact Bosch technical support to resolve the issue

We hope this article has been helpful, and you've been able to resolve error code 17 on your Bosch washing machine. Thank you for reading, and until next time!