If your AEG dryer is displaying error codes on its control panel, there's no need to panic. These codes are diagnostic tools designed to help you identify and resolve issues. The list of error codes that we provide below covers a broad range of possible failures, from obstructions in the ventilation system to load imbalances or electronic problems. You just need to locate the error code that is displayed on your AEG dryer and follow the corresponding suggestions to solve the problem, in accordance with the guidelines that we have explained within the article.
We have a problem with the water supply either due to obstruction or lack of pumping.
There is a generic fault with the drain. The causes can be very varied-
A temperature much higher than normal has been detected and as a preventive measure it has been stopped.
There is a problem with the door sensor that says it is not closed when it could be.
There is a failure in the electrical circuit and the causes can be very varied.
We have a failure in the electrical part where both the cause and the possible solution are more difficult.
Here we have a problem with electric voltage or contact with water so it is a delicate error to solve.
Possible failure in the resistor or another spare part because it does not stop heating up.
There is a power surge that must be carefully addressed.