Aeg Dryer Error e10

What is the fault of the error e10 Aeg that is affecting your dryer?

The e10 error code is a common problem in AEG dryers. It is a code that notifies the user when there is an issue with the water supply. This may be related to an obstruction in the flow of the pipe or the pumping of water.

Identifying the e10 error code is easy. All the user needs to do is turn on the dryer. If the error appears on the screen, it indicates that there is a problem with the water supply and action needs to be taken to resolve it, otherwise the machine will not be able to work properly. Note that this type of error applies to AEG integrated washer-dryer or freestanding models.

Below we list the possible causes that can generate this error. Don't be discouraged, this error is completely fixable and the best part is that you can do it yourself:

• Empty condenser: The condenser is a water tank located under the dryer. If it is empty, the necessary steam for the drying task cannot be produced. Therefore, it is necessary to fill the condenser before starting the machine again.
• Clogged filter: The filter contains particles and lint, and if they accumulate, they can block the flow of water. To solve this problem, it is necessary to remove the filter from the machine and clean it carefully.
• Broken pipe: This can occur if the pipe is broken. In this case, it is necessary to replace or repair the pipe to correct the error.
• Problems with water inlet: It is possible that the water pipe is not compatible with the dryer or that it is not open enough to allow water to flow. In this case, it is necessary to check the pipe from the faucet to verify that the water supply is properly feeding.

How to solve the error e10 of Aeg dryer?

To solve the e10 error code on your AEG dryer, we can recommend the following actions:

1. Restart the dryer: It is possible that the error occurred due to a system failure, so it may be possible to solve it by disconnecting the dryer, waiting a few minutes, and reconnecting it.
2. Fill or check the condenser: If the condenser is not full or not functioning properly, it should be filled or checked to prevent the problem from occurring.
3. Clean the pump and filter: A clogged filter or dirty pump can be quite problematic for your appliance. It is necessary to carefully remove and clean to prevent the problem from recurring. This filter must be cleaned periodically.
4. Check the drainage hoses: These should not be clogged, excessively bent, twisted, cracked or broken. If these hoses are in poor condition, you will need to find a replacement.
5. Verify that the drainage pipe height is correct: The height of these hoses should not exceed 100cm and should be no less than 60cm from the base of your AEG washer-dryer.
6. Check the water supply: Make sure the faucet is completely open and that the water flow is abundant and constant. Otherwise, this error will appear on your machine and you will not be able to use it to its full capacity.
7. Use less powder detergent: Excessive foam can be problematic for your washer-dryer. Try using less detergent, turn off the machine, and rock the drum back and forth several times to help dissipate the foam.
8. Repeat all steps if the problem persists: If the problem is not resolved with the above steps, it is necessary to repeat them until the problem is solved.
9. Consult with a qualified AEG technician: If you are unable to solve the problem, it is best to consult with a qualified AEG technician who can help you resolve the issue.