Aeg Dryer Error e20

What is the fault of the e20 Aeg error that is affecting your dryer?

Have you detected an error code e20 on your AEG dryer? If so, don't worry! In this article, we will explain why you may encounter this problem and we will try to guide you in a friendly and close way to solve the AEG drying machine error step by step.

What are some of the possible causes of the e20 error? We have prepared for you a series of possible causes that may cause your precious appliance to have this e20 error code. However, we anticipate that the problem is most likely due to a drainage failure:

• An electrical discharge in your AEG dryer: This means that a power surge has erased the data stored in memory, so you will need to restart your dryer to try to solve the problem.
• The dryer's drainage is obstructed for some reason: This means that the water remaining in the dryer between cycles is not draining properly. Check the drainage to make sure there is no obstruction.
• The drainage pipe of your dryer is not connected correctly: This means that the water will not go down where it should even if the drainage is not blocked. Disconnecting and reconnecting the drainage tube may help solve this problem.
• The machine is not properly centered: AEG dryers are loaded with a suspension system to level the load. If it is not properly centered, the drainage process will not be completed efficiently.

How to solve the error e20 of Aeg dryer?

After reviewing these 4 possible causes of the e20 error code, we can continue with our list of solutions:

1. Restart the dryer: This can be as simple as unplugging it for a few minutes and plugging it back in. Sometimes this allows the machine to perform a reset that will make it function normally again.
2. Check for any obstructions in the drainage: Check if there's any item inside the drainage, such as a piece of clothing or any foreign object that is blocking the flow of water. Usually, lint can cause this type of problem, so you may also need to check the filter. If you find any obstructions, remove them so that the water can flow correctly.
3. Check the filter: If the filter is very dirty, it can cause this type of problem. Make sure to keep it clean and add it to your to-do list when you need to maintain your AEG dryer.
4. Disconnect and reconnect the drainage tube: Make sure all components are perfectly connected and that water flows without problems.
5. Repeat all these steps: If the error persists and you can't solve the problem, you can repeat all the previously mentioned steps.
6. Get help from a qualified AEG technician: If the problem continues and you haven't been able to find a solution, you can seek the support of a specialized AEG technician. This person will help you solve the problem quickly and efficiently.

We hope this article has helped you better understand the e20 error code in your AEG dryer and that you can solve the problem by following the indicated steps.