Aeg washer machine Error ef3

What is the ef3 Aeg error fault that is affecting to your washing machine?

Do you have the "ef3" error code on your Aeg washing machine? You are in the right place to find out what it means and find a definitive solution. The errors with your AEG washing machine can be a headache because they tend to break down without warning and just when we need them.

But there is light at the end of the tunnel, and that is that this type of error has an easy and fast solution, so you have nothing to worry about. Without further ado, we will explain this error and its possible solutions so that you can continue to use your appliance.

The ef3 error in your AEG washing machine or when it emits 15 beeps or 15 flashes can be due to several factors; a faulty door closure, a broken or worn-out rubber seal, dirty or worn-out filters, a broken water pipe, or poor and deficient water supply.

How to solve the ef3 error of Aeg washing machine?

Fortunately, the ef3 error is relatively easy to solve. Here are some ways you can do it:

1. Disconnect the washing machine from the power outlet for a few minutes: This is done to restart its systems, it's like a "reboot" and after this, if the errors were minor or insignificant, they should disappear.
2. Don't use too much powder or liquid detergent: Too much foam inside your washing machine can cause it to malfunction. The foam can clog ducts that are important for its operation, and the washing machine will not work well until all the foam has dissipated.
3. Check the door, especially its gasket: If the gasket that helps keep the door closed is broken, cracked, or expired, then you have a problem with the closure of your washing machine. These gaskets must be in perfect condition for your washing machine to correctly detect the door closure.
4. Check the water filter: When the water filter is dirty or clogged, it will supply the water needed for the washing machine's operation incorrectly.
5. Check the water inlet pipe: Make sure the water tap is open and that the pipe is in good operating condition.
6. Verify that the water pressure is adequate: If the water reaching your washing machine is very low or without force, then it can generate this type of error.
7. Repeat the steps if the problem persists: Make sure you have carried out all these steps correctly. In case the problem persists, you can repeat these procedures without any problem.
8. Contact a qualified technician: As a last resort, if the problem persists, then contact a qualified technician in AEG washing machines to help you solve this problem so you can continue using your appliance.