Aeg washer Error 11

What is the fault of the error 11 Aeg that is affecting your washing machine?

What is the AEG washing machine error 11? Basically, it is an indication that there is a problem with the water inlet, which can prevent the washing machine from functioning properly. This AEG washing machine error usually happens when there is something blocking the washing machine's water inlet.

This situation can arise for many different reasons, here are some of them:

• Small or clogged pipe: If the pipe that supplies water to your washing machine is too small, short, or clogged, then the supply will be insufficient.
• Dirty or clogged water filter: If you haven't properly maintained your AEG washing machine for some time, this could be part of the problem. The filters must be cleaned regularly to ensure proper functioning.
• If you have a water heater at home, you may have a problem: Some water heaters tend to send very little water to your washing machine, especially when it is shared by everyone in the house.
• Blocked or clogged water tank: Another possible reason may be that the washing machine's water tank is blocked.

How to fix Aeg washing machine error 11?

Now that we have a slight idea of what is causing the error 11, let's see how to solve it. Here are some tried and tested solutions you can try to fix the error 11 on your AEG washing machine:

1. Reset your AEG washing machine: You can do this by unplugging it from the electrical outlet, waiting for about 30 seconds, and then plugging it back in.
2. Check the drainage hose: This hose should not be inserted more than 10cm. It should not be blocked, obstructed or stepped on by any other furniture, wall, or object. It should also be in the correct position, slightly elevated so that it can drain all the water that it no longer needs. The correct height should not exceed 100cm or be below 60cm from the base of your washing machine.
3. Do not abuse the soap: Too much soap generates too much foam, and this can block the water level sensor in your washing machine. So you will have to turn off your washing machine and shake it back and forth repeatedly so that this soap dissipates a bit and you can put it back to work again.
4. Check the water filter: It must be clean, free of debris, and unclogged. If not, you will have to clean the pipe and clean the water filter.
5. Increase the water input pressure to the washing machine: To do this, you can change or adjust the water pressure regulation valve of the heater.
6. Check the water tank: This water tank must be clean and free of obstructions. Otherwise, you will have to clean it.
7. If the problem persists, repeat all the steps: Make sure you have correctly performed all of these aforementioned steps. Review all the points and repeat if necessary.
8. If the problem persists, seek help from a qualified technician: It never hurts to have a professional in AEG washing machines check your appliance to perform routine maintenance. Surely, with this, the error 11 in your washing machine will disappear.